Expanded battery storage. Built-in inverter redundancy.
- Solar
- 25 kW
- Inverter
- 12.8 kW
- Battery
- 38.4 kWh
Summary
This Ballarat home and shed workshop runs entirely off-grid on 22–25 kW of east/west-facing solar and 36.48 kWh of usable Pylontech battery storage. Two Victron MultiPlus-II 8 kVA inverters provide 12.8 kW combined continuous output and built-in redundancy, so the system keeps running on one unit if the other fails. A wall-mounted touchscreen, labelled breakers and organised cable runs make monitoring and servicing straightforward.
Off-grid power for a home and shed workshop, with dual Victron inverters and 38.4 kWh of battery storage.
Approximately 22–25 kW of solar panels span east- and west-facing roofs, with separate charge controllers managing each roof section. Two Victron MultiPlus-II 8 kVA inverter/chargers provide redundancy, allowing the system to operate on one inverter if the other fails, within the remaining unit’s capacity.
The Pylontech battery bank has since been expanded from around 18 kWh to 36.48 kWh of usable storage. That roughly doubles the stored energy available overnight and during periods of low solar production. 16 kVA combined inverter capacity: two × 8 kVA units. In kW, that’s 12.8 kW continuous output at 25°C when operating together: two × 6.4 kW.
A wall-mounted touchscreen shows system status. Labelled circuit breakers, organised cable runs and a displayed installation layout make the equipment easier to identify, monitor and service.
- Solar array: Approximately 22–25 kW across east- and west-facing roofs.
- Inverter/chargers: 2 × Victron MultiPlus-II 48/8000/110, rated at 8 kVA each.
- Solar charge controller: Victron SmartSolar MPPT RS 450/200-Tr.
- Solar charge controller: Victron SmartSolar MPPT RS 450/100-Tr.
- Additional solar charge controllers: 2 × smaller Victron SmartSolar MPPT units.
- Battery storage: 8 × Pylontech US5000 modules in a floor-mounted rack. 38.4 kWh nominal capacity, with 36.48 kWh rated usable storage.
- Monitoring: Victron wall-mounted touchscreen display.
- Communications: Victron communications/control module.
- Electrical protection: Individual circuit breakers for batteries, charge controllers and inverter circuits, plus an enclosed switchboard.
- Cable management: Cable ducting and enclosed cable runs.
- System documentation: Wall-mounted installation layout showing equipment and disconnection points.





